Description
Program 1: Water Fun
When the button is pressed, a cold mist rain with very fine water droplets begins. A minty, cool scent spreads through the cabin. Blue light shines and the sound of the sea can be heard. To connect, the lowest pair of side showers begins with cold water. After an adjustable time, this is replaced by the middle and later by the upper showers. While the overhead showers are running, the water temperature changes to warm and the light changes to red; the side showers gradually change from top to bottom. Finally, the cold mist shower with fragrance runs again.
Program 2: Tropical Rain
After pressing a button, the shower begins with a warm drizzle. The lighting automatically changes to a red-green color cycle. A fruity scent fills the cabin. You can hear birds chirping. After an adjustable time, a warm tropical rain sets in, falling onto the shower area with thick, soft droplets. The rain weakens and the program ends with the drizzle. At the end of the program, the lighting changes back to room light, the drizzle with fragrance and the music turn off.
Program 3: Mediterranean
The program begins with cold mist. The lighting automatically changes to a red-green-blue color cycle. A thunderstorm can be heard in the distance. After an adjustable time, a light, warm drizzle is added. Then the cold mist stops and the program ends with the warm drizzle. At the end of the program, the lighting changes back to room light, the drizzle and the music turn off.
SCOPE OF DELIVERY
Water Fun ID1 control panel consists of:
2 x inlet with pre-filter and ball valve MS 3/4" FNPT
Thermomixer JRG 3/4" with check valves
8 x outlet with solenoid valve 1/2" and screw connection 1/2"
2 x diverter valves for hot and cold water
2 x drainage for the pipes to the submerged nozzles
2 x dosing pumps with fragrance storage container and empty alert
2 x dosing valves for injecting the fragrance into the line
2 x microprocessor control EDS1 in housing
Fully piped and pre-wired on gray PP mounting plate
The nozzles, lighting and button panel must be ordered separately.
ON-SITE REQUIREMENTS
Technical room / cabinet for placing the control panel
Power supply
Cold water connection 3/4"
3/4" hot water connection
Required pressure at the transfer point: flow pressure 3 bar
Water volume max.: 92 l/min
Pipes to the spray nozzles
Drain / sump in the technical room
2 x pipe isolators according to DIN EN1717 in the inlets